IP ACL Application Configuration

I



Table of Contents

Table of Contents
Chapter 1 IP ACL Application Configuration............................................................................................... 1

1.1 Applying the IP Access Control List............................................................................................... 1
1.1.1 Applying the IP Access Control List....................................................................................1

II



IP ACL Application Configuration

Chapter 1 IP ACL Application Configuration

1.1 Applying the IP Access Control List

1.1.1 Applying the IP Access Control List
After an ACL is established, it can be applied on one or many slots or globally.

Run the following command to apply IPv6 ACL on a port:
Command Purpose
config Enters the global configuration mode.
interface g0/1 Enters the to-be-configured port.
[no] {ip | ipv6} access-group name Applies the established IP access list

to an interface or cancels it on the
interface.
Name IP: Name of the ip access list

exit Goes back to the global configuration
mode.

exit Goes back to the EXEC mode.
write Saves the settings.

Run the following command in global mode:
Command Purpose
config Enters the global configuration mode.
[no] {ip | ipv6} access-group name Applies the established ip access list
[vlan {word | add word | remove to an interface or cancels it on the
word}] interface in the global configuration

mode.
NameIP: Name of the ip access list
Vlan THE ACCESS LIST IS APPLIED
IN INGRESS.
WordVLAN RANGE TABLE
AddADD VLAN RANGE TABLE
Remove Delete vlan range table

exit Goes back to the EXEC mode.
write Saves the settings.

Note: In the global configuration mode, the IP access list can be applied to VLAN and in the

1



IP ACL Application Configuration

interface configuration mode, the IP access list cannot be applied to VLAN.

2