Interface Range Configuration

I



Table of Contents

Table of Contents
Chapter 1 Interface Range Configuration........................................................................................... 1

1.1 Interface Range Configuration Task......................................................................................1
1.1.1 Understanding Interface Range.................................................................................1
1.1.2 Entering Interface Range Mode.................................................................................1
1.1.3 Configuration Example................................................................................................ 1

II



Interface Range Configuration

Chapter 1 Interface Range Configuration
1.1 Interface Range Configuration Task

1.1.1 Understanding Interface Range

In the process of configuring interface tasks, there are cases when you have to
configure the same attribute on ports of the same type. In order to avoid repeated
configuration on each port, we provide the interface range configuration mode. You
can configure ports of the same type and slot number with the same configuration
parameters. This reduces the workload. Note: when entering the interface range
mode, all interfaces included in this mode must have been established.

1.1.2 Entering Interface Range Mode

Run the following command to enter the interface range mode.

Proced Command Purpose
ure

1 interface range type slot/<port1-port2 | Enters the range mode. All ports included in this mode
port3>[, <port1-port2|port3>] accord to the following conditions:

(1) The slot number is set to slot.

(2) The port numbers before/after the hyphen must
range between port1 and port2, or equal toport3.

(3) Port 2 must be less than port 1

(4) There must be space before/after the hyphen (-) or
the comma (,).

1.1.3 Configuration Example

The following example shows how to enter the interface configuration mode of
gigabit Ethernet interface 1, 2, 3 or 4 on slot 0.
switch_config# interface range gigaEthernet 0/1-4
switch_config_if_range#

1